Samsung HCN473W 47" Rear Projection Television "040 heat" Questions

...two large black ICs mounted onto a large aluminum heat sink. they should be stamped with STK392-040 on them. can you locate the board on the right? Does it have the two large heat sinks on the

...heat sink. Samsung is known for making the fuse devices hard to find. Let me know if you need more help....T. THANK YOU, TO TERRYFIC, HE WAS SO QUICK, TO ANSWER,AND TOLD ME THE RIGHT SOLUTION TO ...

...heat sink compound while your there. Then lable your wires on the tv that you remove. Desolder both STK392-040 chips and solder in the new ones. Just ve careful not to bridge any of the pins with ...

...040. The only similar part I can find in town is a NTE7178. Are these part compatible? I wouldn't use a generic replacement part, use only original OEM ( cost is about $25,00 each) you can check at ...

...heat sink allows STK4274 STK4275 STK4278 STK391-110 STK391-120 STK391-220 STK392-010 replace with STK392-040 STK392-020 replace with STK392-040 ***The -040 has wider bandwidth and has higher current ...

...IC's are on the left of the TV, looking from back, the TV uses STK 392-040 (two) convergence IC's. They will be mounted on a large heat sink (large silver/metal) looking device. Good Luck, big

...040 is both heat and static sensitive, so your $19.95 radio shack special soldering gun could ruin them in a blink of an eye.They're mounted on the board against a large aluminum heat sink on the ...

convergance I put in the new STK392-040 in my Samsung projection tv. It had STK392-010 in it, and now the green out of sink no blue and it heated up piece up on the board. What are your thoughts? You ...

...040 Sanyo built Ics at board location Icz103 and Icz104 and usually one or more pico fuses and some low ohm resistors. F1018 sometimes opens due to stress but generally it's just the two 6.3 amp pico ...

...040 semicconductor on projection tv. i have taken off heatsink box to try to gain access to semiconductor. but cannot take them off. any suggestions. can you buy the whole board or do you have to ...