Samsung HLP6163W 61" Rear Projection HDTV-Ready Television "dlp lamp inch" Questions

dlp tv Most likely the tv projection lamp life are ending.The tv projection lamp been inside this tv like 1 1/2 or 2 years?Tv been on watches like 4 or 5 hours each day?The tv projection lamp life are

...dlp tv. No picture with 3 blinking lights in the front. Just replaced bulb and color wheel 1 year ago. all 3 lights blinking means lamp has a fault the service manual says replace the lamp. If you ...

...DLP Lamp will fail in two ways. 1.The glass tube housing the filament will shatter and the TV will not turn on. 2. The lamp has many hours of use on it and will gradually grow dimmer. At no time will ...

...lamp I have a Samsung DLP HLR5667W 56 in Rear Projection HDTV for about 4 years and I replaced the lamp last week. After I replaced it, there's about an inch-wide shadowy column appeared on the left ...

...DLP If all fans are running then its your Lamp BP96-00826A and if Lamp is Good then it will be Lamp Ballast BP47-00021A Lamps only Last for 5,000 hrs some Last up to 8,000hrs Call FOX 1-800-227-5369 ...

...lamp, the TV came on but went out in about 15 minutes with all three lights blinking. DLP 61 inch, TV will come on but will go out in about 15 minutes. Power issues (Tv not turning on) were typically ...

...INCH)GREEN INDICATOR LITE (LAMP) COMES ON AND I HEAR A WINING SOUND THAN SECONDS LATER THE SOUND ONLY IS ON ,...SECONDS LATER ALL GOES OFF AND INDICATERS ... TIMMER, TEMP A AND LAMP STARTS TO FLASH ...

...a 51 inch.samsung dlp tv it has a good pic and sound It has a hum or a buzzing i thought it was the lamp humming but dont really know the humming usually means the Color wheel bearings are going

...DLP samsung and it wont power on after making a lot of noise (I replaced the lamp) worked fine for a few days now the red light and the right side green light is blinking. any sugge the TV worked ...

...DLP when you can see the lamp is working is ALWAYS the DLP chip. BECAUSE you recently replaced the color wheel, i suspect that the LVDS/data cable to the light engine was not plugged in well and has ...