Question about RCA Televison & Video
...red picture tube---the bright red screen causes the set to draw too much current and the shutdown circuit detects this and turns set off--self protection. Each picture tube (3) has a IC chip on the ...
...tube.That board sends red,green, and blue video and information to the picture tube via 3 pins on the tube (the K or cathode for each).The set will have either 3 IC's on that board or 3 ...
...red on me is my tube gone prima sreen goes red on me. Is my tube gone and if not can it be repaired. no ur tv must be had loose contact in video board section...or..driver transitor or driver ic may ...
...red. I had a television that went to a bright shade of blue.A friends neighbor worked for sony television plant where the new tubes came down the assembly line.His job was to make sure tubes were ...
Question about RCA Televison & Video
case you'd have to replace the red tube. Are there horizontal (slightly slanted) lines through the picture as well when this is happening and a very very bright screen? If so it's most likely the tube
...circuitry connected to the red electron gun of the picture tube. This would include the red amp and the red driver transistors. You will need a schematic and a multimeter to properly test these
...red gun on the tube if it is a tube tv. It could also be a weak red gun in the tube itself and may need rejuvenated. Or maybe it can also be a bad solder joint on the PCB that connects the yoke ...
Question about Toshiba Televison & Video
...red and the green light flashing Sorry to say, but that's usually the sign of a bad picture tube. One of the elements inside the tube shorts and you see the picture you describe, and the set shuts ...
...tube base and cross couple the red video output stage to the green cathode pin and the green output to red cathode pin using wire links. If set now comes on with bright red raster the fault is in the ...
Question about Sony Televison & Video
...tube this case red canon measure and compare the red green and blue tube canons on crt print to each other on the tube foot between massa (secundair cold earthpoint on the chassis) and if you have ...
56 questions posted
Usually answered in minutes!
1,423 Questions
661 Questions
607 Questions
562 Questions
482 Questions