...of valve is turn to on. Can you here the gas valve click? It igniter comes on and a delay and the gas valve should come on. Kill power to furnace to reset control board. Rus Let me know how it
gas valve will open. The control board then monitors for flame prove through another sensor located near the burners. If there is no flame within 3-5 seconds, the gas valve closes. It will repeat this
Question about Heating & Cooling
...Gas valve control knob or electric switch, ON/OFF 5. Gas Valve 6. Gas burner 7. Ratting plate 8. Blower door safety switch 9. Blocked vent safeguard tube and switch 10. Gas Manifold 11. Manual limit ...
Question about Goodman Heating & Cooling
...gas valve wont open (roll out switch failure) My GMP075-3 will start and fire for about 1-2 minuites then the gas valve will close and the unit will not restart. When I test voltage accross the valve ...
Question about Honeywell Heating & Cooling
...gas valve (24 volts). Either a pilot will come on or the burner tube will ignite then spread the flame to all burners. Lastly a safety sensor will be looking for a certain temperature within a few ...
...Gas Valve. When the heater tries to cycle on the Exhaust fans runs after 30-45 seconds, the Ignitor glows and the Gas valve clicks the the burners will light. I have checked with a DVOM and 24 volts ...
gas valve trying to open. Have you verified you have gas to the valve? Loosen the flex connector and check. Is the switch on the valve in the "on" position? If you have gas and the valve is on, either
Question about Goodman Heating & Cooling
...gas valve (24 volts). Either a pilot will come on or the burner tube will ignite then spread the flame to all burners. Lastly a safety sensor will be looking for a certain temperature within a few ...
Question about Williams Heating & Cooling
...gas valve. Worked last winter. Now it will spark 8-9 times but will not light pilot. Any electrical measurements I can take? i had this problem a couple years ago and I had to scape where the flame ...
...gas valve (24 volts). Either a pilot will come on or the burner tube will ignite then spread the flame to all burners. Lastly a safety sensor will be looking for a certain temperature within a few ...
802 questions posted
Usually answered in minutes!
87 Questions
47 Questions
43 Questions
32 Questions
17 Questions