Toshiba TW40F80 40" Rear Projection Television "service 18 mode" Questions

...18 times [usual start mode of a tv w/o any problem] then the tv is on. But after a minute or so, the tv resets itself [or power cycles itself] and now there are about 53-to-54 blinks on power/standby ...

18-month old Samsung HL-S6188W (61" DLP) it is in a mode where none of the on-screen graphics (like the active input or volume level) show up. Also only some of the video inputs will actually get

...18 watts versus the original stk392-110's which were 11 watts, the tv is still going into protection mode after the high voltage supply for the crt's tries to come on, where should I look next? Also, ...

...18 PIN Single Inline Package IC`s STK392-150. The original chip cost $75 , i bought the exact same chip ( generic ) frome someware for $ 5.47. I installed the chips myself ( good job ) and turned on ...

18 2power on You should now be seeing the secret service menu. TOUCH NOTHING IF YOU DON'T KNOW WHAT IT DOES!!!!!!!!! Before you touch ANYTHING write down what the initial setting was. I mean it mister

...service manual from Pioneer for this and have worked on many of them. MAIN PROBLEM WITH YOUR SET IS THE POWER SUPPLY BOARD DEVELOPS BAD SOLDER CONNECTIONS DUE TO POOR SOLDERING AND EXPANSION AND ...

service grid (64 point grid) 5) When you first get in here? I believe red is the selected color by default (it is flashing). 6) To choose other colors to converge, use the following buttons on the R/C

service grid (64 point grid) 5) When you first get in here? I believe red is the selected color by default (it is flashing). 6) To choose other colors to converge, use the following buttons on the R/C

18 ) When green dots appear, initialize operation is finished. 19) Turn power OFF. 21) Wait a few seconds. Turn the TV on, and you should have your normal signal. Press Magic Focus button just to make

...service the tv? If it was serviced, how much did they charge you? If you've already replaced the convergence IC's and confirmed the coolants in each tube are filled, you probably need a factory level ...