Toshiba 57H82 57" Rear Projection Television "hyper board caps replace" Questions

...HYper board? What is the full name of this PCB? Thanks, Ed Wilson hyper board is nat made anymoore just replaced 10 10uf caps inside. hyper board is not longer avable replace all 10 10uf capss inside ...

...hyper board and remove procedure hyper board removal procedure and location Hyper board is located directly behind the input board, this is where all the tv conections are, then they are two tabs ...

...hyper board Does anyone have a board diagram where the caps are that need to be replaced? I was able to replace all but one. I apparently dammaged the board & do not know where the contacts go. It's ...

tv is pulled in on sides pix was distorted replaced caps on hyper board now pix is pulled in at sides Replaced the 2 convergence ICS in the hyper board u well solved this problems.

...much in the hyper board and that's likely the problem.. Simply remove the hyper board and open the can. Inside you'll see a number of smd caps. There are 11 10mf/16v that need to be replaced... ...

hyper board It started having a wavy picture when first turned on; after about 10 minutes the picture would be fine. But it's gotten worse over time. It displays wavy horizontal lines all over

...hyper board or fix the hyper card? Hi, My set has the horizontal jags! Everything syncs except for the video. The only way I can describe it is the frame buffer has sahiftess that creates multiple ...

...Hyper Board location UZ01 stamped MVPU14. You will need to have a technican remove the board and replace all the 10 uF @ 16 Volt SMD caps p/n 24619040N found on that board. The Hyper board is no ...

...Hyper board processes all signal from tuners and all inputs in the set and is NO LONGER AVAILABLE FROM TOSHIBA. It can be removed and sent out for "rebuild", last one I did the net cost for this was ...

...hyper board part #23148024 is NLA. There are 2 solder tabs on each side of the board that have to be usoldered from the signal board and then the hyper board will unplug. I do not recommend changing ...