Toshiba CZ32V51 32" TV "single vertical line center screen" Questions

Ad

Question about Zenith Televison & Video

3 Answers

...output ic is defective or theres no power supply to the vertical ic.check the parts that is connected to the vertical ic one by one, you have to got a lot of patient for this. ty single line of ...

Ad

vertical one is not. This results in a display of a single horizontal line (or in my case, a few superimposed) in the centre of the screen. Where both X and Y (horizontal and vertical) deflectors fail

Ad

...single horizontal line then immediately relays clicks then turns to stand by mode. i already change the vertical ic. Vertical scan output failure. That is the reason for this horizontal line, right ...

Question about Symphonic Televison & Video

1 Answer

...picture at all just a black screen with a single line through the center, horizontally. Any suggestions? Hi You have defective Vertical output IC. This parts need to replaced to back to normal. ...

...single line in the center from top to bot It's a rca 36 inch model f35100st with serial # 250760268 vertical deflection failure. either solder on vertical ic, or bad capacitors in vertical circuit, ...

Question about Televison & Video

1 Answer

...single horizontal line in the center indicates a problem with the vertical circuit. WIthout the make and model of your set, there is little I can do. In most sets, there is a vertical IC which is a ...

Question about Toshiba Televison & Video

1 Answer

single hoizonal line across the center of the set.Has my picture tube gone bad? No, your picture tube is fine. This is a problem in the vertical circuit that deflects the beam up and down. This repair

Question about Sony Televison & Video

1 Answer

...single horizontal line is a problem with the vertical circuit. Look for a small flat id attached to a heatsink that should be marked LA7837 or something similar. Try resoldering the pins of this IC ...

Question about Symphonic Televison & Video

1 Answer

...vertical deflection voltage-doubler circuit. The usual fault is a single capacitor of 100uF/35V that has failed. It is normally connected to a rectifier diode right at the vertical IC. Replacing the ...

...single trace. Be careful not to leave this at high brightness for any extended time as it can "burn in" that area of the screen. Unless you are a "techi" this is a job for a qualified technician. ...

Not finding what you are looking for?
Toshiba CZ32V51 32" TV Logo

32 questions posted

Ask a Question

Usually answered in minutes!

Top Toshiba Televison & Video Experts

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

matt martin
matt martin

Level 3 Expert

1259 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you a Toshiba Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...