Question about Panasonic Office Equipment & Supplies
...E4-02 this code shows there is some problem in fuser unit 1.pull out side fuser unit from copier 2.check it is movig easily 3.check all gears 4.check thermostate and thermistor 5.bearings and seals ...
...e4-02 error code E3-40 - Copy Density Sensor output adjustment 1. Sensor connector is disconnected. 2. Sensor is defective. 3. SPC PCB connector is disconnected. 4. SPC PCB is defective. 1. clean the ...
...E4- 02Paper Jam1. Paper Jam in Fuser Unit. 2. Paper Exit Sensor 1 or 2 is disconnected. 3. Paper Exit Sensor 1 or 2 is defective. 4. DRV PCB connector is disconnected. 5. DRV PCB is defective. 6. SPC ...
Question about Panasonic Office Equipment & Supplies
...E4-01 means you have a fuser warm-up temperature problem. try a lbp fuser reset in service mode. i dont know what you password is so i cant tell you how to get there but good luck press functin then ...
...E4- 01 Fuser Warm-up Temperature Possible Cause(s) 1. Fuser Thermistor dirty. 2. Thermistor position incorrect. 3. Thermistor defective. 4. Thermistor connector disconnected. 5. Fuser Lamp connector ...
Question about Panasonic Office Equipment & Supplies
E4-01, but there is the way to reset just followinf the steps; 1, press and hold down following 3 keys by order "function", "original size", "3". 2, enter 9, press print,enter 04 press print. 3, press
error 04-02 i take it you mean E4-02, This is a Paper Jam in the fuser section, I would inspect the fuser/ paper exit sensor 1 or 2! maybe remove and reinstall fuser Hope this helps
e4 02 error code I can't print only scan. At the screen appears E04-02. How can I solve it??? Paper Jam Causes 1. Paper Jam in Fuser Unit. 2. Paper Exit Sensor clear and close the front cover
...E4-02 occurs after 7 consecutive jams at the fuser. Possible causes are: Paper exit sensor# 1 or 2 disconnected or defective. DRV pcb is disconnected or pcb is defective. SPC pcb is disconnected of ...
...e4-02 pertains to paper jam at the paper exit sensor 1 or 2. sensor 1 is located near at the pressure roller of the fusing unit(orange roller) and the sensor below the fusing unit. Well this usually ...
24 questions posted
Usually answered in minutes!
237 Questions
232 Questions
180 Questions
101 Questions
105 Questions