Question about Sony PlayStation Video Game Consoles & Games
drive to shut the system down that way. I would order a new ribbon cable for the power button. They are not hard to replace and only a few screws holding the cover down to gain access to what you need
...ribbon cable coming from the reset/eject cable is fully inserted in the second connector from the front. If this is not the case, you may want to check out www.playstationclinic.com . This could be a ...
...gain better access to them. After they're all clearly in place, then it's a good idea to use the same needle-nosed pliers to make sure that the ribbon cable did not slightly pull out of place from ...
...ribbon cable is not loose. @nd: check the rear of the console to see if the ac adaptor is pushed in all the way and check to see if the female end is not losse.If the female part is loose the easiest ...
Question about Sony PlayStation Video Game Consoles & Games
...ribbon harness on the pickup itself, which provides the circuit connections to all parts within the pickup, can be severed by this sharp edge, which will disable the pickup and may be difficult, if ...
...gain access to the lens, you need to remove the lens cover. The lens cover is located right in the area where the PS2 ejects the tray out, just above the tray. It's square shaped, and has a small ...
...gain access to the ribbon connectors, release the larger flat connector by hinging the clip up, slide the ribbon out, underneath you will see a tiny connector, gently ease the small clip back towards ...
Question about Sony PlayStation Video Game Consoles & Games
...ribbon cable to the top screen is damaged and will require replacing HTH My screen went blank white ,i red that it could b the cable inside so i pushed my top and bottem screen together while it was ...
31,934 questions posted
Usually answered in minutes!
9,005 Questions
4,769 Questions
1,255 Questions
1,155 Questions
827 Questions