...single voice coil at two ohms the they have to be wired in Parallel that means (Red +) (Black -) are connected to the + and - of another sub and then the (RED +) (Black -) from both go to one output ...
...Sub or multiple Subs with Dual Voice Coils, or multiple Subs with Single Voice Coils, make sure your wiring is correct by checking here: http://www.the12volt.com/caraudio/woofer_configurations.asp 4) ...
Question about Kenwood Car Audio & Video
...sub-woofer into my 2006 Subaru Outback 2.5i (with the standard Subaru head-unit). I have absolutely no complaints with either of these components, the sound is fantastic. However, I do have a problem ...
Question about Car Audio & Video
...single speaker, and how. What is the use of the "hi" inputs with 3 pin miniture plugs, as opposed to the expected "phono" inputs. I shall take a look at the unit gain and come back with more specific ...
...output? Hello..I installed a new head unit,alpine cda 9886 with two rear alpine 5.25 in a jeep wranglers roll bar.I bridged the speakers with an alpine mrp-250.the right speaker sounds great,but the ...
...sub. I have 2 x 4 ohm 3 way speakers with single input for each. The Stereo has Hi level out (x4 for 4 speakers) and a single line out. The Amp has a hi level in (x 4 FR,FL,RR,RL) and a line in for ...
...sub? also what problem would cause a subwoofer to make a slight burp noise whenever the car is shut off or into the non accessory position with the car key in the ignition? Hello, This amplifier can ...
a subwoofer, use an RCA "Y" adapter and connect the single "Sub Out" preamp output from the head unit to both amp inputs. The switch marked "LPF" should be "ON" and the crossover set to about 80-100Hz
33 questions posted
Usually answered in minutes!
114 Questions
80 Questions
69 Questions
73 Questions
63 Questions