...heat and the furnace should start. If it doesn't, look for a fuse that may have blown either on the circuit board or in the wiring. If the unit started by jumping the W and R but does not when you ...
Question about Heating & Cooling
...on... it calls for heat, sparks and the furnace ignites and runs fine till the next time the pilot wont extinguish. Is it my box, thermostat, pilot light or what? this sound like you gas valve is ...
Question about Goodman Heating & Cooling
...thermostat calls for heat, fires normal thru one cycle. after demand is met, and burner cycles off, code2 flashes, inducer says on and wont allow furnace to burn again. I have replaced the pressure ...
...THERMOSTAT OPERATING PROPERLY? IS THIS UNITS FLUE EXHAUST VENTED TO THE OUTSIDE? & IS IT FREE OF OBSTRUCTIONS?, check your vent need 3 feet above roof line to prevent cold air from cooling down ...
...heat or cool. My guess is a lose or broken wire in the thermostat circuit. Try and putting a jumper across the red and white heat terminals inside the furnace and manually closing the door switch. If ...
Question about Goodman Heating & Cooling
...heat, the 24 volt thermostat sends a signal to the control module. The control module will indicate a call for heat with a light on the control either blinking or remain solid depending upon model. ...
Question about Goodman Heating & Cooling
...heat, the 24 volt thermostat sends a signal to the control module. The control module will indicate a call for heat with a light on the control either blinking or remain solid depending upon model. ...
Question about Honeywell Heating & Cooling
thermostat sub base. If not there, install a short jumper to power the heat side of the system. If there IS a separate wire on each of the Rc and Rh terminals, you have to check to make sure there are
Question about Goodman Heating & Cooling
...heat, the 24 volt thermostat sends a signal to the control module. The control module will indicate a call for heat with a light on the control either blinking or remain solid depending upon model. ...
...heat, the 24 volt thermostat sends a signal to the control module. The control module will indicate a call for heat with a light on the control either blinking or remain solid depending upon model. ...
1,187 questions posted
Usually answered in minutes!
416 Questions
195 Questions
147 Questions
138 Questions
100 Questions