Goodman GMS90703BXA Heater "gmp075 3 furnace blower motor" Questions

...GMP075-3 The thermostat was in the off position over night and sometime during the night, the induced blower and blower motor came on. The trouble light on board blinks 5 times. I checked all safety ...

gmp075-3 which is the main limit switch ? Red service light blinks 4 times. The limit switch is a credit card size shaped switch right behind the burners which has two wires attached to it. This ...

Furnace fan will not turn on. I've checked every connection I can find. Is there a reset switch somewhere? Goodman gmp075-3 time to change the blower motor

...GMP075-3 your limit switch is opening up, that causes constant fan. Check for flashing codes after flame shuts off and fan continues. Check airflow, filters, lack on return air for possible hi temp ...

GMP075-3 intermittantly will run then shut off and not start The furnace vent motor is not starting consistantly after 4 hours of being turned on I can turn it on and the furnace runs for 20 minutes ...

...gmp075-3 led blinks 5 times I have a goodman/janitrol furnace model number gmp075-3. when the t-stat calls for heat the fan turns on and the status light flashes 5 times, which is false flame sensed. ...

...GMP075-3 not igniting. Everything cycles as it should but HSI does not glow. Thermostat is set to heat, temp approximately 10 to 15 degrees higher than room temp, blower motor starts, relay clicks as ...

...was so dirty that is why overheated?? I have a goodman GMP075-3 that won't turn on. I think it is the pressure switch since I do not have a vent blockage. What is a venter and where can I find

...GMP075-3 will start and fire for about 1-2 minuites then the gas valve will close and the unit will not restart. When I test voltage accross the valve and it read 0. So I powered down the furnace ...