Oreck XL Edge. What is red wire in the handle? Question edited for clarity. It is a ground earthing wire to prevent static from synthetic carpets and the spinning nylon brush giving you a shock. 63. ...
...wiring diagram for the Oreck XL? I just can't read the one that's on-line. Thanks, [email protected] I would advise you to ALWAYS to FIRST UNPLUG THEIR VACUUM before beginning any service procedure. ...
I had a loose wire in my Oreck XL motor. I took it I had a loose wire to my Oreck XL motor. I took it apart and fixed the wire, and plugged something wrong as I burned out the lights immediately. Are ...
formed metal wire inside handle I have an Oreck upright XL. I took the handle apart to fix a wire and I can't figure out the exact position for the bent metal formed piece that fits inside the handle.
...xl upright it did not come with wiring diagram Your new motor should be very similar to the old motor. Compare the two motors to see if you can determine where each wire on the old motor should go on ...
Question about Oreck Vacuums
...xl classic. The bad motor is out and i do not know exactly where the wires connect on the new one. I need a wiring diagram. Hi, it's Jeremy from Crucial Vacuum. Below you will find a link for many ...
My Oreck XL has worked very well until the power cord was pulled out of it. I figured how to hook up the hot but can not figure out the neutral connection. any ideas? if there are two wires it doesnt ...
I have power to my orteck xl bagged unit but it wont I have power to the xl bagged unit but it wont start! check the cord that goes from the handle to the brushroll housing. these usually go bad by ...
Oreck XL upright Need legible schematic for handle wiring. Can you help? [email protected] I just sent you tge diagran to your email, hope this will help.
111 questions posted
Usually answered in minutes!
230 Questions
49 Questions
34 Questions
29 Questions
18 Questions