...Fuser Unit Yes)Check the resistance of the Rear Thermistor between P600-2 and P600-4 . The resistance is 3k ohms or higher. No)Replace the Fuser Unit Yes)Check the wire between J410 and J600 for an ...
...either disassembling the fuser and replacing the thermistor ( if you can find one) or replacing the fuser assembly. so i would suggest that take it to nearest service centre of lexmark. best of ...
...Fuser thermistor 10-302 Low fuser temperature 010-304 Bad fuser temp 10-308 High fuser temperature or open thermistor 010-310 High fuser temperature 010-312 Fuser not up to temperature after energy ...
...device Fuser thermistor (middle front) - thermal control device Fuser thermistor (rear) - thermal control device These items wear out. Change at the same time. Fuser needs to be rebuilt or
...Fuser thermistor, 010-302 --Low fuser temperature , 010-304-- Bad fuser temp, 010-308 --High fuser temperature or open thermistor, 010-310 --High fuser temperature , 010-312 --Fuser not up to ...
...Fuser thermistor (middle front) - thermal control device Fuser thermistor (rear) - thermal control device These items wear out. Change at the same time. Fuser needs to be rebuilt or replaced. (Check ...
Question about Savin Office Equipment & Supplies
...thermistor. open the right side and the front cove, the fuser is located on top of the OPC carriage unit, push the blue level going to the right side while pulling the fuser unit. after removing the ...
...thermistor check failure. Fuser page count between 0 and 99,999. ? Noisy thermistor signal. ? Intermittent connection. ? Thermistor cable not connected or thermistor actually open. Go to ?924.xx?Hot ...
8 questions posted
Usually answered in minutes!
1,105 Questions
603 Questions
557 Questions
331 Questions
354 Questions