...code of simulation 2) Entering a main code with the 10-key → START key ON 3) Entering a sub code with the 10-key → START key ON 4) Select an item with the scroll key and the item ...
...- Fuser UNIT Perform the following procedure to enter the simulation mode. "#" key Interrupt key CLEAR key (c) Interrupt key Main code [START] key Sub code [START] key Main code = 14 Sub code = ...
...lamp low temp detection. Sometimes you can reset that code via simulation 14 in service mode. If the code cannot be reset, you will need to have the lamp and maybe temp sensors in the fuser
...SIM 14. Entering the simulation mode Perform the following procedure to enter the simulation mode. Clear key ® Interrupt key ® "0" key ® Interrupt key ® Main code ® Start key ® Sub code ® Start ...
...simulation; F2 with sub code 37 - drum mark sensor adjustment required.You may post further comments for more help or information...... Good Luck!! Thanks for using FixYa!! how to clear the F2 error ...
wasn't given enough time to warm up, or the room was cold. You can reset this code by entering simulation mode. #,*,C,* Then press 14 and copy button. Reboot the copier, and this should clear the code
Question about Sharp Office Equipment & Supplies
What does the code H4-00 on a Sharp AR-C260 copier mean? low temparether When lamp fusing or termofuse have problems or in morning whether was cold input simulation 14 - 1
...AR-156, with code H-4 H4: Heat roller abnormally low temperature. cause:- Thermistor failure Heater lamp failure MCU PWB failure Thermostat failure Power supply failure Execute Simulation 14 to ...
Question about Copystar Office Equipment & Supplies
code "Simulation 163" which reset copier fine. Later it gave the same code so I ran simulation code again then ran Sim 199 to watch the fuser temperature.It varied the high temperature from 187 to 234
...code, get into the simulation mode by pressing the "#" key, the interrupt key, the "C" key then the interrupt key again, in rapid succession. When you get to the simulation mode, type in "14" then ...
58 questions posted
Usually answered in minutes!
1,105 Questions
603 Questions
557 Questions
331 Questions
354 Questions