Sharp AL 1631 Copier "blink 4 again" Questions

...4 LED will blink 4 times. Release the button ST1+READY immediately after 4 blinks 4)PRESS ST1 - ST1+READY+EJECT starts blinking 5)again PRESS ST1 - ST1+EJECT+ST2 starts blinking 6)again PRESS ST1 - ...

...4 alone it is usually followed by a H that is H4. Try to key in the following C Auto C Auto then enter 14 and press Copy key. If it was power low voltage , it will not re-appear but if it comes back ...

...same number again. 1 blink - jam in feeder sensor 2 blink - jam in manual feed 3 blink - jam under toner 4 blink - jam in output are 5 blink - jam in tray 1 6 blink - jam in tray 2 (if

...installed incorrectly. Try opening the door, removing the cartridge and installing it again. It should snap into place. 4.There is a paper jam. Remove the cartridge and check if there is a paper

...button 4 times.Press power button and the printer power will off. otherwise off, depress again power button.And the turn on the printer again, your printer canon iP90 should be response as

...blink mode. When it blinks, it alternates 4X between orange and grenn, and then pauses on green for about 2-3 seconds, before alternating again. Pls help, thanks. The alternate flashing of orange and ...

...blink and come back. also tried in safe mode. any suggestions would be appreciated. thanks. Well you can tryforcing the driver out,, 1.) click Start, right clcik mycomputer and select properties 2.) ...

again! For Printer Model: Canon S9000, S300, S400, i550, i560, i850, i860, i865, i9100, i9950, PIXMA iP3000: 1. Turn off printer 2. Hold down Resume button and press Power button. 3. Keep holding down

After switchin ON, it starts blinking. printer is not operating Take out output hopper and clean the printer interior with a blower. Fix hopper again.

light blinking 1. there is document in the queue but paper is out 2. Cartridge problem (remove and insert again) 3. Communication error 4. Cover is open