Hitachi 53UDX10B 53" Rear Projection Television "need change pin number green" Questions

...pin when unsoldering and do not make a solder bridge between pins when soldering the pins.  After installing you may need to adjust the convergence with the menu to the cross hatch that will ...

change C603 and S901.. But I could not locate a part number on the web... so do you know where I can get them and what to order? C603 is a polyestor capacitor 0.068UF-FEB 50V part number 0880047R S901

...number on the ic will begin with STK392- ??? there will be two of them and the pins will need re-soldered, or the part will have to be replaced. If you even just solder the pins it is a good idea to ...

...number printed on them in white--they are located on either one large metal heat sink with fins or two smaller heatsinks that are side by side. If you have ANY questions or need help reply to this ...

...change them back. Ok, the things you need to adjust the football effect are pin, and key. Also you may have to work with the bow settings. Pin is what's pushing the corners towards the center of the ...

...need schematics or part number to figure which one it is before I start taking it apart ant thoughts? Usually there are 2 convergence IC's, labeled STK392-110. Each IC has 3 channes. Each color needs ...

...need to do this repair----you can save the set and a lot of money--most shops get 300 for this kind of repair. If you get someone else to fix it--MAKE SURE THEY REPLACE BOTH CHIPS--some clowns will ...

...need to check all the feed resistors to those IC's for change in value. I have RARELY changed out the convergence amps and not found at least one of the feed resistors had changed in value. In that ...

...number 1 problem of it. if your not so sure better to send it to technician to change or replace some parts of it. or use your warranty if it has. CHARCOIS If you get nothing other than the green ...

...number off hand, when you take off the back in the middle there is a board with 3 plastic caps. take the wires off this board. take the caps off and there is some screws inside this is the lining up ...