Hitachi 60SBX72B 60" Rear Projection Television "logic led tv" Questions

...logic hence, giving you blinking LED's. recheck Ballast board where you have small 4pin plugin make sure pinns are not bent together and that it is pluged in correctly only thing lefted could be Bad ...

...LED is not blinking, it just turns off. There can be several causes for this, few of which you can do anything about. However, a few things to try: 1) Replace the batteries on your remote control. 2) ...

...current and the answer is a dark picture as i told you already.the lamp blown (of course the tv cannot work and the LED "lamp" turns on or keep steady on the front panel with a complete dark

...led indicators that appears.. to blink or flashing? try to pull the power plug for about a couple of minutes and after that turn it on. see also the settings of your tv and manual of it. if all ...

...TV technicians who are also engineers agree that this works, but the cost due this method is not a good one, you still do not take care of the central problem which actually is sharp increases of ...

LED's do not tell us what is wrong, sometimes it may indicate the "Area" in your case it is the X board. BUT thats NOT where the "Fault is" thats just the part that is affected. These days unlike the

LED's do not tell us what is wrong, sometimes it may indicate the "Area" in your case it is the X board. BUT thats NOT where the "Fault is" thats just the part that is affected. These days unlike the

LED's do not tell us what is wrong, sometimes it may indicate the "Area" in your case it is the X board. BUT thats NOT where the "Fault is" thats just the part that is affected. These days unlike the

LED's do not tell us what is wrong, sometimes it may indicate the "Area" in your case it is the X board. BUT thats NOT where the "Fault is" thats just the part that is affected. These days unlike the

...Led TV says it gets no signal. The TV worked fine one day then the next day when power was turned on, it has a blank screen with the message there is "no signal". I used all the same wiring and ...