front panel. 2) While ?Magic Focus? is running, press Magic Focus button again to ?Stop?. 3) Press ?RECALL? or ?STATUS? button after ?STOP? OSD appears on the screen to enter digital convergence mode.
Thank you for your time in this matter. John Its located in the front behind the speaker panel there s a nother small access panel the convergence board is right there on the right hand side up front
...panel front side : http://www.pc4you.us/sam/Front.JPG There is a pictures from the panel back side : http://www.pc4you.us/sam/Back.JPG I found a this SITE that carries that convergence assembly for ...
front panel by removing the screws on the back edges secured to the front to the cabinet,also remove the small screw behind the front control door - the front comes off - remove access panel,there you
...front panel where the speakers are then the small access panel you will see the convergence module right there in the front. It will have the two Convergence ICs attached to that heat sink. They are ...
...front panel which is either held on by velcro, or by screws in the sides put in from the rear, and usually a couple behind the little door in the top center. There will be another panel covering the ...
...front panel. 2. While the button is held down, then press the INPUT or ANT button on remote control. 3. The unit will now be in the DCAM. NOTE: 1. Proceed with digital convergence adjustment. 2. ...
...front behind the speaker grille and small access panel its the first board after the access panel its on the right side rectangle board. You can get a convergence board at the following link just ...
...front panel off my Sony 46in projection tv to adjust the red line conversion. You cannot - or should not adjust the convergence manualy. The TV has a built in flash focus button on the front panel ...
78 questions posted
Usually answered in minutes!
727 Questions
631 Questions
405 Questions
415 Questions
357 Questions