BenQ PB6110 Multimedia Projector "screen shuts down seconds" Questions

...shuts down after few seconds If I power up the projector, it will stay few seconds on and show the screen. After few seconds it shut down with LAMP/COVER led lights On. After cooling time it goes to ...

...screen shuts off. The red light blinks on a 6 blink cycle while the orange light constantly blinks until the projector shuts off and stays as a steady orange light while the red is still blinking on ...

...screen and then it shuts down. Try below....It worked for me. Here's the fix: Take off the top cover of the projector. Unplug the wire leading from the two fans in the back of the unit to one of the ...

...shuts down When I power up the projector I get the blue screen, then whit screen looking for input, the the light goes out and unit turns off. The whole process take 53 seconds. And it will repeat ...

...shuts off. the screen shows "Retrying..." as it tries to, i believe, restrike the lamp. it starts to light up again and the lamp flashes on but then it all just shuts off to stand by mode. Can anyone ...

...shuts down in 45 seconds to 2 minutes. Filters are clean and unit has been shut off for over 24 hours. Will not stay on. Hi there Is there any on screen prompting ? If not , open up the lamp door at ...

...shuts down. Try turning the display on again after the projector cools down. If the problem persists, contact Dealer. 5. If the TEMP light is blinking orange, a projector fan has failed and the ...

...shuts down after 30 seconds - dust problem ?? replaced lamp as diagnostic red leds told me to do and yet when i power up the red led blinks twice still it will not allow me into a screen to reset the ...

...screen then after about 10 seconds ther is a hum type noise which sounds like a fan trying to run then the unit shuts down and shows two flashing red lights. What do you think it is and can i repaire ...

...shuts down after 30 seconds. I changed both fans on this projector because they were making noise (bad bearings). the unit will now power up (Much quiter) the bulb lights up, i can go to the menu and ...