Canon FAX-B820 Plain Paper Bubblejet "line recieve faxes" Questions

...recieve and you should be fine. Make sure you using a seperate analog phone line and not a digital phone line. If you have DSL on your phone system you may need a filter on the phone line as

...recieve fax Recieving faxes Plug a regular, non-digital, phone into the fax's phone line and see if you get a dial tone If you do not have a dial tone, seek support from your telephone service ...

...other fax we send does not go through, and we get a transmission report that indicates "ng: poor line condition" -- is the problem on our end or the recievers? If our's, how do we fix it? It

...recieve. Does the machine actually answer the incoming call? If so does it give an error code? Are you using the genuine brother line lead? Finally make sure the line lead is plugged into the "line" ...

does not recieve I have a fax jx200 the machne that sends fax messages but does not recieve. Does the fax need some special configuration when working with voip line? Try to "slow" down the fax "speed

...recieve (not recieving like it does when it is working) Any ideas are greatly appreciated. thanks It seems that the protocol is failing. Just check, by printing a receive report. If there are errors ...

...recieve and send faxes to other fax machines with no problems. Do you know of anything that might be the cause of this? this sounds like may be there is a phone line problem on those two machines or ...

...line as your fax machine. To set the Recieve Mode : Press Recieve Mode. The LCD display shows your current selection. Continue to press Recieve Mode until your new selection appears. After 2 seconds ...

...them. it is on it will send faxes but not recieve them. it is on auto. Be sure the fax is on the proper phone line. You can send on any line but you can only recieve on the line for your number. ...

...faxes but can't send. After I load the fax to be sent into the document feeder and I type in the fax phone number I hit send and nothing happens. The display says:" Enter Station(S) Then Press Start ...