Canon IMAGERUNNER 3530 Copier "jams exit rollers" Questions

rollers at the exit area are worn out. They can be changed, in the mean time you can use something like sand paper to rub across the rollers to take the smoothness out of them. That will help them get

...Exit jams are frequently caused by exit sensors. These sensors are typically mounted on the fuser assembly or adjacent to it. They are plastic arms that block and unblock an optical sensor. The arms ...

paper jam. paper tore at the exit roller. I paper jam. paper tore at the exit roller. I can't access it FUSER ASSEMBLY NEEDS TO BE REMOVER/REPLACED, THE COST AND LABOR MAY NOT BE WORTH THE REPAIR

...printer out, cleaned rollers, used to jam on pick up rollers but now jams on output rollers..getting fed up so reverted to expensive inkjet printing for now. fuser is faulty.exit sensor not ...

...exit rollers. - clean the exit rollers. Paper catching on the duplex guide assembly. - Remove and reinstall the duplex guide assembly. Fuser not fully seated. - Reseat fuser REPAIR/INSPECT/PREVENT ...

...jams at its last paper in fuser unit end.. even fuser unit has been cleaned, how to get rid of this error e02 ? hello dear you have to verify all the exit sensor related 1. do u have look on fuser ...

...jams just after coming out of the fuser unit and stops right before it goes through the outlet rollers After the fuser, problably near the exit rollers, there is going to be a switch/sensor, that has ...

lock down printer prints page then locks down as it exits the upper roller and holds the paper in the exit roller which creates a paper jam error? Is sounds like your exit sensor actuator has been ...

...exit rollers are not spinning so paper doesnt get pushed through to the output tray. If this is the case then you will need to replace the exit roller drive motor and possible the PRCB too as ...