Dymo LabelWriter 330 Thermal Printer "thinks paper" Questions

...paper pops up when label is sent to it. Thinks it is out. Make sure that the label roll is in VERY TIGHT and installed correctly, and then make sure the wheels on the spindle are on correctly (had ...

...thinks it's out of paper. I also noticed that the labels tend to slide toward the middle while exiting. After each print I have to pull the labels back in and realign them. Then the process repeats. ...

Dymo LabelWriter 330 print problem When I select "Print", it goes through the process like it is going to print -- the light is on steady; it asks if the printer paper is correct; the job is listed in

Printer keeps printing blanks... It keeps printing blank labels until it runs out. Not sure how to sort this problem. Only way to stop it so far is turn it off or when it runs out of paper. Blue light

Dymo LabelWriter 450 Twin Turbo - Until recently worked fine from both sides. Suddenly, no longer printing from left - prints half a label, then stops, then error message says Out of Paper, the blue ...

...thinks no paper in tray Brother printer. Light is red saying no paper in tray. Blue marker on left doesnt go down to move paper in tray up therefore printer thinks no paper. I think there's a problem ...

Keeps giving an out of paper warning when it is not out of paper. I think you may need to have your paper feed sensor replaced.  It's hard to troubleshoot such a problem without being there are ...

...paper but it still thinks it is jammed there has to be a tiny piece of paper stuck in there some where. It can be a very small piece. Check again, use a flash light if you have to, to get a really ...

photo paper too thick causes jam I have used 9 mil photo paper for a year. No problem. I received some new photo paper and it causes jams. It will not print. I think it is too thick. Is there an ...

paper jam dm e my printer keeps saying it has a paper jam from the paper tray (i think is dm into the back feeder (i think it is e) There is not! what could cause this? Is it fixable? Clean the sensor