Question about Audio Players & Recorders
...protect mode No power is being supplied for the tuner and CD player while in the protect mode. Maybe there's a correlation to those devices being attached. Float the the amp so it has no cables to ...
...Protect mode happens when the amp detects a problem internally and shuts down to prevent further damage. The most common cause of this is shorted output transistors. Without takeing measuremetns ...
protect mode. A problem was detected in the final stage of the amp and the unit shuts down to prevent further damage to either the amp or speakers. Check the speaker wires to be sure that they are not
PROTECT Mode issue My receiver works fine via its tuner section inputs (AM/FM). When in this mode I can crank up the output to at least 75% and only have trouble tollerating the pain in my ears. ...
and ohm them out. Find out which one is shorting. I've had this problem before. It's fine until you turn it up, Then the receiver turns off and goes into protect mode. It's just a short in the wiring,
protect mode due to heat detection. Try to see if there is a pattern to when this behavior starts. Does a lower volume level allow the unit to run longer? Perhaps there is a problem internally that is
mode and shuts itself down. Due to a change in address I recently had to move & re-connect the unit for the first time, but everything seems to be connected properly & the speakers seem to be in phase
...protect mode", check for blown speakers or shorted speaker wires, sometimes even a source can be a problem(DVD,CD PLAYER,TAPE DECK,ETC.) There is an electrical short present in your system somewhere, ...
36 questions posted
Usually answered in minutes!
122 Questions
52 Questions
65 Questions
48 Questions
61 Questions