Marantz SR-7200 Receiver "ic problems" Questions

...happens change that I.C I'm sorry, but I must disagree with the last post from VOTIT concerning the IC amp section. Believe the problem is going to be further back in the processor section, and that ...

...i turn the system on it comes on and powers back off. what is the problem. You have a defective amp ic and also a open protect fuse in the side where the ic is bad.these output ics are expensive ...

Instead of using ic csc 2313f, what kind of ic can i use to solve problem? There is no substitution for thei IC.  The original number should be used.

...volume tuned off too) that I fear speakers will blow. Any ideas or should I toss this $1000.00 peice of audio and go back to Pioneer/Sony? If I remember correctly there was a problem with the DSP ...

I have a kenwood KA-94 home stereo intergrated power amp in which the output ICS on one side short out.Last time the ICS were replaced, it ran for an hour but shorted again! Any thoughts on the ...

...of the ff: your receiver left fuse is blown, check if it has a user fuse at the back. or your main IC amplifier for the left channel is bad. you need to replace that IC, but check first the wiring

...find any visible damage or shorted diodes or transistors on power supply.Could it be the TOP258MG ic? Hi Ridgep. Replacement of the TOP258MG IC Should resolve your problem. Make sure you have fully ...

When I turn the receiver on, it shuts off after two seconds. I have had a similar problem in the past when speaker wires touched but this is not the case ,I also tried holding the power button down ...

...it on with nothing hooked up too it it immeadiatiy shut off? thanks Always be the audio amplifiers IC's damaged.Good luck can you explain in English? How to fix this problem? i think your unit have

i am facing a problem with akai woofer the internal woofer IC's are burning every time when ever i replace the new IC's i want to know which recomended IC's i use to Replace pls guide me as soon as ...