...that the channel faders control the AUX3 level as well as the aux out level. Make sure you use TRS balanced lines to your speakers and not TS
...that one DO NOT plug mono 1/4 inch plugs into the mains output 1/4inch jacks as those are TRUE TRS balanced
KNOB must be turned up. Also the AUX master gain KNOB must be turned up. Make sure your cablles are balanced TRS cables from the mixer to the powered speakers
...An external drum machine should be connected to a line input for one of the channels USING a TRS balanced cable. Page 28 of your user manual shows the block diagram and signal flow diagram. The ...
Question about Ideas Music
My Peavy XR800F just had all its pots replaced and now iam getting very low output.. any ideas please ? All pots(faders) were purchased direct from Peavy USA and fitted by very experienced electronics
...should be around unity during use. It is nice if the main fader can be around 50% or more. Use BALANCED lines everywhere including those running to the
We have no Volume control on any of the mic's the master and the volume controls for each mic does not work. we have to use the trim to control the volume. Possibly you are using the audio from the ...
I'm running a tape player into one of the mic channels, then out the tape out; problem is any stereo presence is lost. Is it possible to run a 1/8" to RCA in the RCA in, route that to the level ...
...where the hum is coming from and what I can do to reduce/eliminate it? Make sure you are using BALANCED audio interconnect cables AND that the speakers and the mixer are powered from the SAME ...
...level" and not controlled by volume controls. Tap off the INPUT to the amp... you should be using balanced lines for the interconnects. RCA jacks are unbalanced lines. You can drive several inputs ...
16 questions posted
Usually answered in minutes!
124 Questions
35 Questions
24 Questions
13 Questions