...Print head is VERY not open. Have switched on and off. Installed new roll of ribbon and problems started afterwards. No problems before. Should you wanna call, my cell is 704-244-1223 Thanks David if ...
Question about Paxar MONARCH Office Equipment & Supplies
...ribbon between the print head and the ribbon guide, then turn the ribbon tightening knob to help feed the ribbon into place, it shouldn't be twisted or creased. C. Slide the print head from side to ...
Question about Epson Office Equipment & Supplies
...print head and ribbon guide, turn the ribbon tightening knob to help feed the ribbon into place; its not be twisted or creased. select the print head from side to make sure it moved smoothly ...
...print the card the ribbon keeps breaking and I have to wrap it and print again, this happens all the time is there any solution remove the ribbon and make sure the winding is correct. It sounds like ...
...slide to the right (up the printhead) so...when you close, the ribbon is no longer over the sensor....thus the error message. Just try sliding the ribbon to the left (down the print head) as you ...
...print again. Possible Cause: •Ribbon may not be synchronized on the correct color panel position. Solution: •Open lid, then close lid to synchronize ribbon. Possible Cause: •Cards may not meet ...
...disc printed!! Help!!!! Check the ribbons. If your CD image is still on the color ribbon your print head is probably bad. If the image is on the transfer ribbon replace the heat
Question about Paxar MONARCH Office Equipment & Supplies
...print head open on Zebra 6m plus. Load ribbon and stock close head and it will start to calibrate then the error print head open comes up. 2 new sensors have been installed by a Peak tech. Is there ...
Question about Fargo Office Equipment & Supplies
ribbon out, and rewind it a little bit and see if you see print on it. if you dont, chances are your printhead is either bad or has loose cables going into it. if you do see print, either your card is
print head,The label and the ribbon are sticking together. Make sure that both ribbon and media paths are clean (no glue, or sticked labels). Make shure the ribon and the media are corect installed on
11 questions posted
Usually answered in minutes!
43 Questions
24 Questions
17 Questions
13 Questions
1 Questions