Fender Passport 150 PRO Portable PA System "channels 2 cable" Questions

we have a pmp6000 mixer hooked up to our ep 4000 and b1800 and b2520,it seems we can only hook up the amp to the mixer into either mono's 1 and 2 or the main 2 however not in main 1 with full ...

...2. I assume that the hum exists without any cables plugged into the input. If that is not the case, then make sure all input cables and source are using BALANCED lines. If the hum is present with no ...

...channels no info Try this qiuck solution as it works most of the time: Switch off your DSTV Decoder or Unplug power supply cable at rear of Decoder. Remove your Sim card and wait 90 seconds. Switch ...

two inputs you would drive them balanced into the XLR connectors from a single balanced source and reverse pins 2 and 3 in ONE of the connectors of this Wye cable into one of the two inputs on the amp

...channels to SOLO, Sub1-2 or Sub 3-4 and/or main L-R. You should have the bottom button for each channel punched down to L-R. NEVER connect ANYTHING other than an external effects unit to the INSERT ...

...cable to copnnect the first 2 1/4 inch jacks on the snake to the left and right inputs of the crossover. then, from the crossover, connect the sub power amp to the "low" stereo outputs of the ...

...channels but displays one channel. Is it my computer's audio jack that needs service or should I replace mixer? Sounds like the output cable from the 802 is not correctly pinned to your input ...

...channels. also. my amp has to be in channel 2 position (with the button on the head) before i can use the footswitch. sometimes the input/footswitch jack wears out and you need to bend the internal ...

...2) connectors are used simultaneously, their sensitivity is the same (both LOW). This may be your problem however--- Try swapping input chanels to see if the problem follows ther cable or is in the ...

...cable on channel two is perfect. Any ideas? This sounds bad... I suspect that a noise suppression cap on one side of the bad channel has shorted... possibly due to a static discharge. Test for this ...