Rockford Fosgate P3001 Car Audio Amplifier "vibe sub" Questions

...speakers to my vibe sub u dont want to wire ur speakers to the subs, either get a 4 channel amp and wire them into it or to ur deck directly.the reason u dont want to that cause ull blew up ur ...

...vibe. Also I want to run 4 12's at 300 watt rms wired at 2ohm. Wire from channel 1 to sub one them directly to sub 2. channel 2 to to sub three then straight to sub 4. Hello dreww1005, If your ...

no sound from subs Pontiac Vibe Stock Radio displaying " - - - " for amps Hooked up to 2 JL Aduio 10" subs (daisy chained) No sound is produced. ? The output disable mode is turned on. ? Refer to the ...

lanza vibe I have had a lanzar vibe 251 amplifier fitted to 2x 12inch pioneer subs ts-w307d4 installed. What cross over settings should i set on the amplifier to get deep rolling bass instead of the ...

Lanzar Vibe 1200D protection light here's the deal, i've had my Lanzar Vibe 1200D for about a month and a half or so and have been running it and have been very happy with it. However, the other day, ...

...sub,and a set of vibe k-series 69's that have a max power of 525 watts. I tryed wiring the sub with the speakers and the speakers sound fine but the sub should be playin a LP frequency so the sub ...

wiring I have the Lanzar vibrant bridgable 2 channel amp with 400 watts rms. I have tried a lot of solutions for the to hit on my 2 12 inch subs it doesnt seem to be working. In all reality, that amp ...

...vibe 225 500W amplifier and a 1000W lanzar sub hooked up the other day 1 of the connector clips from the sub to the box slipped off as far as I can tell I have good connections now but the amp keeps ...

...sub box, specs are 1100 w peak power, 600w Rms, 87dB sensitivity, 30Hz-200Hz, 4ohm. I'm looking for an amp to power them. Any suggestions? The Lanzer Vibe 416, 1000 watt amp seems compatible & is in ...

i have a Lanzar Vibe 235 amp. the green power light is not coming on, but the red "protect" light is. how do i solve this problem?? your amp has a power supply problem,contact eric @ Capital Audio ...