Question about Mitsubishi WD Televison & Video
...I had the wrong TV Model #. the lamp is simple; yet you can run into problems with this tv. be very careful replacing lamp. the plug in the tv can be damaged. (due to the design) lamp part # ...
Question about Mitsubishi WD Televison & Video
...tv off or back on for a few minutes. Then the process starts again. If you have never replaced the Lamp,then it will be Lamp ,But if the Lamp has been replaced it will be Lamp Fan. Mats sells ...
...LAMP LIGHT TURNS RED AND THE TV SHUTS ITS SELF OFF.WE HAVE RESET TV,AND UNPLUGED IT.DO NOT HAVE AN INPUT BUTTON ON FRONT TO DO A SELF DIAGNOSIS.TV WAS PERFECTLY FINE BEFORE OUR LAMP BLEW.PLEASE HELP ...
...lamp, the TV screen comes on but after a few seconds, the screen goes off and the lamp light goes unblinking red. I suspect it is really the ballast and not the lamp that is the problem, but I can't ...
Question about Mitsubishi WD Televison & Video
TV suddenly shuts off and lamp light comes on, but lamp is OK A few days ago I tried to turn wd-62827 set on and it acted like it would turn on, but instead it went dead and the red lamp light came on
tv on, the lamp light stays yellow and I get the green timer light. I've noticed a beep sound after a fews seconds thta lasts a few seconds then goes off and comes back a few seconds later. I think it
...tv picture&sound did not come on. Lamp statu was red; Replaced lamp with new one provided by Mitsubishi - no change i.e., no picture no sound. Disconncedted, reset no help...What else beside a bad ...
Question about Mitsubishi WD Televison & Video
...lamp and the TV worked fine until the other day. I have tested the lamp on a WD-52525 and it is working fine. I would suggest it is a ballast problem. You can check supply of 5 volts to ballast's ...
...the fans because if theyre not working the DMD board receive that info and turns the tv off also it could be also the ballast that could not be regulating the voltage to keep the lamp on, good luck
Question about Mitsubishi WD Televison & Video
...tv after replacing lamp. Lamp manufacturer advised me that after changing bulb, tv must be reset or tv will go into safety mode and will not turn on. To do this on my model WD-65734 you must hold ...
76 questions posted
Usually answered in minutes!
1,423 Questions
661 Questions
252 Questions
240 Questions
221 Questions