Question about Brother MFC Office Equipment & Supplies
...from the tray area was not whole so I know some paper remains. Thanks, Mary Try removing the fuser to check inside of it and behind it for paper scraps. (Note: the fuser gets extremely hot, so ...
Question about Brother MFC Office Equipment & Supplies
...fuser. Both are near the center of the paper path. Look for a black plastic lever sticking out of a slot. They snap into their pivots, and if you pull a jam out backwards, they might stab through the ...
fuser drawer. 2. extend the fuser drawer 3. remove the 3 front covers of the fuser drawer 4. remove the three black screws that secure fuser motor, 5. remove the yellow cover to access then two screws
Question about Canon Office Equipment & Supplies
...fuser drawer. It will allow you to fully extend the fuser drawer to remove the fuser unit. You have to remove the 3 front covers of the fuser drawer, remove the three black screws that secure the ...
...fuser itself If you're sure the drawer closed properly, then it could be the pressure load home switch is not working, either fallen screws or out of alignment. Obs; AC remote/ *** PWB , relay and ...
...fuser drawer. In the fuser drawer, there are two black plastic parts that can go up or down. Their function is to push the belt cleaner on and off the accumulator belt after every pass. A defect in ...
sharp arc 262 paper jam at fuser unit Turn off machine, open drawer where fuser unit is and gently pull out the jammed paper. You may have to replace the fuser unit.
Question about Toshiba Office Equipment & Supplies
fuser cover,side cover (T/S block section), duplex cover, drawer 1 cover (just below bypass), optional drawer cover (if there is LCT or LCF) 2) Replaced the feed, separation rollers for the drawers, 3
...Thermistor Inspect the surface of the Heat Roll for excessive wear due to the Thermistor. Replace the Heat Roll if necessary 6.Check the Drawer connector at the rear of the Fuser for damaged ...
Question about HP Office Equipment & Supplies
Paper Jam in fuser on my CP2025. I have opened all drawers and doors and was able to find jam. but a small piece of the paper was torn and inside of the fuser assembly. Any way to open fuser assembly?
106 questions posted
Usually answered in minutes!
1,135 Questions
1,012 Questions
743 Questions
623 Questions
406 Questions