Brother HL-2040 Laser Printer "nylon stuck" Questions

...stuck on to the sides. carefully pull them out to free the feed. Also check for any dirt on the feed, you can use a good cleaner mildly soaked to wash off the dirt on the rubber rollers. open up the ...

...STUCK BEFOR THE OUT TRAY hi, paper passing rollers have dirty. clean the small (rubber, Nylon) rollers on the delivery section. ok or one sensor hold in (yellow foamed) plate middle of the delivery ...

...off. There is also a roller motor which feeds the paper. This has nylon gears which can make a grinding sound if one of the gears gets stuck. Make sure there are no pieces of paper stuck in the

...nylon lever arm back on, and think nasty thoughts about the brainiac who designed that part. reverse the above steps. Put at least most of the screws back in, or the front panel may fall off at a ...

...stuck or impeded, and thus gives the annoying error. What I did: 1) Remove the scanner assembly (it comes off with a few screws, and is a totally separate unit; The printer works with it completely ...

...nylon) in the machine. Unfortunately, I have no way to get into it to examine the exact location of the damage. They built it in almost one piece. But there is a design or manufactring defect in this ...

stuck on them which does not allow the rollers to roll freely and hence is as bad as paper jam. The idea is that the rollers do not roll whether because of paper or some dirt on the roller teeth. They