Brother HL-2040 Laser Printer "fuser error cold" Questions

Question about Brother HL Office Equipment & Supplies

Error 50 display

error 50 display Likely, your fuser is bad. However, there can be a problem with little pcb (circuit board) that sits almost under the fuser. Check the P2 connector and see if it is loose on the pcb. ...

Question about Brother HL Office Equipment & Supplies

1 Answer

Green light keep blinking after switching on. Then

...fuser error . I myself check by shoving my finger near and then on to grey/brown and orange fuser rollers at rear, but if its working ok then you will have a badly burnt finger....if the fuser is ...

Question about Brother HL Office Equipment & Supplies

2 Answers

All four lights are blinking.

error, all four lights, usally needs fuser, sometimes laser depends on what is indicated when one presses and holds the go button either way it needs to be workshoped to enable repairs to be performed

Question about Brother HL Office Equipment & Supplies

1 Answer

Error button is on saying paper jam, i got the

...fuser unit. HOT SURFACE After you have just used the printer, some internal parts of the printer will be extremely hot. Wait for the printer to cool down before you touch the internal parts of the ...

Question about Brother HL Office Equipment & Supplies

1 Answer

Hi there I have a

error light blinks BArry You should be able to solve your issue by following the first 7 steps below for clearing paper jams. After that put your printer back together and see if it starts working. If

Question about Brother HL Office Equipment & Supplies

1 Answer

Paper keeps jamming, remove it and the light does

Question about Brother HL Office Equipment & Supplies

1 Answer

I got a Brother HL

Question about Brother HL Office Equipment & Supplies

1 Answer

I have a c920 lexmark with a fault code 920.000.

fuser. Some 920.xx error codes may be cleared by turning the printer on and off. In general, fuser errors require replacement of the fuser. Fuser errors can be from a cold fuser or an overheated fuser

Question about Xante Office Equipment & Supplies

1 Answer

177 Fatal Error

Error. Usualy the fuser has overheated first (error 172/176) and tripped the thermal protection causing the fuser not to heat up anymore. Normal procedure if a restart doesn't fix it is to replace the

Question about Brother HL Office Equipment & Supplies

1 Answer

ERROR

ERROR 921 Fuser Error Indicates that the fuser is below standby temperature when the printer is idle. Error codes 920, 921, and 922 may display for a cold fuser failure. A 920 error caused by low line