Question about Brother MFC Office Equipment & Supplies
fuser. Some 920.xx error codes may be cleared by turning the printer on and off. In general, fuser errors require replacement of the fuser. Fuser errors can be from a cold fuser or an overheated fuser
Error. Usualy the fuser has overheated first (error 172/176) and tripped the thermal protection causing the fuser not to heat up anymore. Normal procedure if a restart doesn't fix it is to replace the
ERROR 921 Fuser Error Indicates that the fuser is below standby temperature when the printer is idle. Error codes 920, 921, and 922 may display for a cold fuser failure. A 920 error caused by low line
Question about Brother MFC Office Equipment & Supplies
...fuser error has occurred. There may be a problem with the printer's fuser, or inadequate external or internal power supply/line voltage. 1. Turn the printer off, and turn it on again. 2. Remove the ...
fuser error on the hp 3700dn printer When I try to print on my 3700dn series hp printer it says fuser error 51 what do I do? You need to replace the fuser since it is most likely caused by a bad fuser
...FUSER ERROR Description A fuser error has occurred. Action Turn the printer off. Verify the fuser is properly installed and fully seated. Turn on the printer. If the message persists, contact HP ...
...FUSER ERROR, COLD FUSER ERROR, ASSUMING CONECTOR ON FUSER OR A WIRE IS A PROBLEM If your fuser is actually getting hot, then it is likely the temp sensor. It looks like a mylar pad that should be ...
fuser error 50.1 and it is cold. Hello, The fuser error 50 means that the fuser heater lamp is blown and you need to get another one (whole assembly). I personally use printerworks at www.printerworks
error Turn the printer off, and turn it on again. Remove the surge protector or Uninterruptible Power Supply (UPS) and connect the printer directly to a power source. Try a different power cord. Try a
error 921 fuser help This indicates that the fuser isn't heating up enough and is too cold. Either the thermistor, bulb, or power supply is on the fritz. I would replace the fuser if I were you.
202 questions posted
Usually answered in minutes!
1,135 Questions
1,012 Questions
743 Questions
623 Questions
406 Questions