Garland AF-5025 Deep Fryer "thermostat working" Questions

cant get my fryer to work basically. Thermostat is turned to a high temp but still nothing. pls help! You need to replace the Thermostat. (Sometimes it's the solenoid prior to the thermostat that ...

working before being cleaned but a cook started it up without the oil now nothing will work? Hopefully it has kicked out on high limit thermostat. It depends a lot ofn what type of control you have on

...working on? American Range only manufactures commercial gas fryers. An American Range fryer thermostat is designed to work with a thermopile and a millivolt gas valve, 1500 mV maximum and almost no ...

Pilot light stays lit when I turn the gas valve to on. But nothing happens when I Turn the thermostat on. Help The thermostat control is bad, you will need to replace the thermostat switch and ...

...working thermostat in the leaking to the other. How hard is that? VERY easy. First, remove the 2 small mounting screws holding the thermostat in place. These are located behind the knob so pull the ...

The fryer burners and pilot works fine but when I try to turn it off by the thermostat the fires go down a little but won't cut off, what could cause this why doesn't the burners go out ...

why does fryer shut down when it hits 200 degrees The thermostat? If your thermostat works normal, it should switch off the heater when the temperature is reached. Perhaps there is a last security, ...

...repair .Unit did work fine other than leak before tank repair.After lighting pilot and then turning thermostat on ,burners did light but would not turn off by thermostat control knob.I immediately ...

...working normally, when you turn the thermostat up past the current temperature of the oil, you should hear and feel a tiny click in the thermostat. If not, the thermostat is defective. If there is a ...

NO GAS COMING THROUGH THE ORFICES Might be the high limit thermostat or the control thermostat. Check your gas valve for continuity. If you have a fuse in line with the control check it for continuity