Question about JBL Audio Players & Recorders
jbl eon 1500 horn tests good 3.9 to 4.2 dc restance but will not work Tested the horn,seems to work fine but when hooked up no sound out of horn You have probably blown a light bulb in the SonicGuard ...
Question about Behringer Audio Players & Recorders
test the voice coil right at the horn`s terminals then with the crossover network connected you would go down the line all to the speaker box terminals to check for an open line. But if you don`t have
...speaker and only about half the sound out of horn 1. Confirm the woofer is not blown. Remove it and test it by using an AA battery and wire from the battery to the woofer terminals. When connected, ...
Question about Behringer Audio Players & Recorders
speaker wires are not 'live' they have a + and - but no electricity flows down them. easy to test. i am assuming the wires do not have connectors on the ends, just bare wires. put the wires into sound
Question about Mackie Audio Players & Recorders
...Remember leds have polarity, check it before. And always power off the speaker, I did blow some motherboard circuits while testing led and an unplugged horn cable did breakdown voltage. Shame on ...
Question about KEF Audio Audio Players & Recorders
test a speaker and horn to see if they work, before I buy. How do I do it? Does blk. lead plug into com and red into Ohm? What should the setting on the ohm meter be for an 8-ohm speaker? What are the
Question about ElectroVoice Audio Players & Recorders
...test it to find out what part of the crossover is bad.... any help??? The crossover network is a combination of a LCR circuit. since all these arre passive components you will not have a problem to ...
...horn) it comes on. Set it back down into it's natural position, and it cuts out again. Slight shaking seems to have no effect. All of the speakers work fine, so it seems as if perhaps a component (in ...
Question about Bob Mackie Audio Players & Recorders
test. I was amazed side by side the eminence was much smoother around 1.5 khz Note: the Mackie mid is 5.9 ohms and the eminence is 6.9 ohms and is 150w One issue is that the new speaker sits about a 1
143 questions posted
Usually answered in minutes!
681 Questions
296 Questions
322 Questions
225 Questions
200 Questions