sandpaper sliding off I have a Craftsman 4'' belt sander, model #315.11781 which I recieved without a manual. I finally slided the sandpaper in by loosening the spring on the side and retighten the ...
Question about Porter Cable Tools & Hardware - Others
I have a Porter Cable Speed Bloc sander and I was wondering how to change the springs for the 1/4 sheet hold down without going CRAZY. I'd tell you but I'd have to charge $12.99. for the info. I went ...
Question about Porter Cable Tools & Hardware - Others
sand paper will not stay on model 505 and i have replaced the springs with new ones? You may need to replace the clamps too. I always replaced the clamps and springs as a set. And make sure the pad is
Question about Tools & Hardware - Others
...Brushes wear out often. Unscrew the brush caps and see if they are worn really low or if the springs are broken. If there is any burning on them, then replace them. Also those brushes
Question about Bosch Tools & Hardware - Others
belt sander Craftsman 315.117150 The spring-loaded bolt that adjusts the front roller has an eye hole into which a spring is fastened to the roller. The eye has broken, consequently I am in need of a ...
Question about Craftsman Tools & Hardware - Others
How do you put sandpaper on a Craftsman 1/4 sheet sander? If you have the sander that is in the picture (and I surely do hope that you do), I can help you. Your sanding felt pad is square, and two of ...
belt will not tighten small round spring come loose do not no where it goes Usually there is a knob with a screw imbedded with a spring around it that screws in and adjusts the "tracking" of the belt ...
how do you change the belt The front roller (usually a metal cylinder) is spring loaded. The rear roller (usually a rubber cylinder) is fixed and is driven by a belt from the motor.&
Question about Ridgid Tools & Hardware - Others
...new rollers, they only go in one way. They do install into bearing blocks that 'float' on springs to keep the rollers tight on the wood being planed and there is a difference between the ...
2 questions posted
Usually answered in minutes!
18 Questions
7 Questions
4 Questions
3 Questions
2 Questions