motor. but it was a good gamble. check to see if you pushed the laser ribbon cable all the way into the new laser and make sure the clamp on the laser is down and locked, before you buy a new drive to
...laser drive motor or bad laser. The solution is to buy agood DVD drive the same as your make and change the pcb boards (thecircuit board in the DVD drive) make sure yor pcb stays with yourconsole as ...
laser or the wormgear motor is slipping , the laser is easy to replace the drive replacment has to have the board swap to a new drive cost a little more. try opening the drive and re-seating the laser
Question about Microsoft Xbox Video Game Consoles & Games
...laser move slightly and the lense bob up and down and light up, third is the spinner motor put and disc in the tray and close the tray the disc should spin up if it doesn't then the motor is bad. If ...
motor is bad when you open and close the tray(small hole on the left front of metal box use a pen tip) observe the laser it should move back and forth just a bit and bob up and down and light up if no
up and it goes to open tray you probley have a dead laser or hub/spindel motor. Its an easy swap for the laser. if the spindel motor is weak ,your going to have to replace the drive and swap the board
Question about Microsoft Xbox Video Game Consoles & Games
...isn't spending fast enough to play a game. Games require a higher RPM to read while movies require a lower RPM. Your laser and/or motor needs changing. Send it in for repair. ...
motor .and all you need is a laser :> the laser is the easy fix ,and cheap about 20.00-30.00 I have never seen a dirty lens just a ring of accumulated dust in side the drive ,probley because of the
Question about Microsoft Xbox Video Game Consoles & Games
...motor refuses to spin, so the laser will not move to read the game. These pics show my tray. There is no problems as far as I see. :/ It's the gold rod on the left in the first pic. ...
Question about Microsoft Xbox Video Game Consoles & Games
...motor that moves the laser back and forth across the disc. A spring may have come loose from the motor causing it to click as the screw occasionally slips from the guides. This should not cause a ...
23,447 questions posted
Usually answered in minutes!
1,345 Questions
747 Questions
281 Questions
262 Questions
173 Questions