2011 Kia Sorento "obd scanner powering" Questions

...check good. any ideas ? Also has a CEL and OBD port has no power. Wont recognize code scanner connection. check all the body grounds..some must not have been reinstalled when the engine was

...OBD Scanner Will NOT Communicat When Pluged IN, and 'read codes' is pressed it read out must connect to VEH TO RUN THIS TEST Checked pins they are good and tested 2006 F350 Power stroke truck ...

...to obd-11 on 2001 pontaic montana Attach OBD scanner to pin connector. turn the key to the "on" position, this brings power to OBD11 connection. follow mfg directions for the scanner you

...YOU PLUG IT IN TO DATA LINK.THE OBD 1 SCANNER WILL POWER UP AT CIGARETTER LIGHTER OR AT THE BATTERY.MY SCANNER IS POWER UP 9 VOLT BATTERY WHICH BRINGS IT UP UNTIL I POWER UP USING CAR

...won't communicate or turn on when plugged into obd connector can't retrive obd codes because scanner won't turn on when plugged in to connector Check for power at d.l.c.if none find blown fuse in ...

...now it has before If this is an OBD scanning tool for automotive, there is a fuse that powers the OBD scanner jack. It is a 5 amp fuse and when it blows out, the scanner wont work. Check the fuse ...

...power at connection pin 16 ground at 4 + 5. have disconnected everything we can think of connected to obd one at a time and reboot scanner each time. still unable to communicate. What about term ...

...OBD but the scanner does not read anything at all. the bulb may have gone out and check the back of the obd plug to make sure no one pulled the diag wire from the plug assembly. Check for power and ...

...engine will not communicate with obd obd scanner wont show any error code Check your cigarette lighter fuse to see if its blown and replace it.Most obd connectors get power from the lighter

...PARTS OF THE VEHICAL WHICH COULD BE THE TRANSMISSION. YOU WILL HAVE TO TAKE THE VEHICAL TO A DEALER FOR A TRUE SCAN. I HAVE AN OBD II SCANNER ALSO AND THIS IS ONE OF THE DOWN FALLS TO THE ...