Question about Konica Minolta Magicolor Office Equipment & Supplies
...end up with a tiny line of multi-color dots running along the very right edge of the paper. Is there an easy fix to this? Any suggestions as to how I could clean it - what to do?? Please help, MR ...
Question about Konica Minolta Magicolor Office Equipment & Supplies
...unit were replaced after low life/end of life message. Printer was working fine up to replacing these items. Immedeatly on pwr up received Imaging Unit missing, contacts were cleaned, unit reseated ...
...fix this? 14: 2nd image transfer pressure/retraction failure Relevant Electrical Parts Retraction Position Sensor /2nd Image Transfer (PC5) Pressure/Retraction Solenoid /2nd Image Transfer (SL4) open ...
Question about Konica Minolta Magicolor Office Equipment & Supplies
...end of the cartridge. The yellow one was really tight and I could not move it with my fingers. I sprayed just a bit of WD-40 on the white wheel and then tried to move it. It took a couple of sprays, ...
Question about Konica Minolta Magicolor Office Equipment & Supplies
...end?? Any help gratefully recieved as this has been a damn fine printer and don't want to give up on it! I think someone touched on this solution briefly, but here is how you fix the problem. Clean ...
Question about Konica Minolta Magicolor Office Equipment & Supplies
...unit. If not try fliping paper over, and try. Next try reversing the paper in the feed tray. Laser paper is produce with zero to very little dust, as compared to ink jet or typing paper. a good 20#, ...
Question about Konica Minolta Magicolor Office Equipment & Supplies
unit which contains the m ultipurpose paper feed. the problem was diving me nits as it turned up on 3 printers I look after! The solution is not too difficult. Firt a quick note of the problem (or you
Question about Konica Minolta Magicolor Office Equipment & Supplies
...end of the cable. Be careful removing the cloth as you can then dislodge the switch again as you pull the cloth out. andy the replacement switches are just as bad as th old ones take it apart and the ...
...the fixing film unit. Is the problem corrected? YES:End. 4.Power supply PCB, DC controller PCB Try replacing the power supply PCB. Is the problem corrected? YES:End. NO:Replace the DC controller ...
Question about Kyocera Mita Office Equipment & Supplies
How do I change out the fuser fixing unit on a Kyocera FS3900 DN 1. Draw the rear unit. 2. Insert a flat-blade screwdriver to push the fuser lock (gray colored) on the rear unit and the fuser unit is ...
290 questions posted
Usually answered in minutes!
321 Questions
244 Questions
182 Questions
115 Questions
97 Questions