ATDC sensor is reading toner supply incorrectly, now this Toner Density Control sensor sits inside the developer unit of this machine, and toner is feed into it, where the atdc sensor reads the amount
...ATDC Sensor Failure • The scanning value of the ATDC Sensor is less than 7 % while the IU Motor is turning. • The scanning value of the ATDC Sensor is more than 19 % while the IU Motor is turning. ...
...ATDC sensor malfunction.Try to change the ATDC sensor gain adjustment value,increase or decrease.If the error persist you must be change the developer and the perform the F8(developer and ATDC semsor ...
ATDC Sensor - The measurement taken by the ATDC Sensor (UN1) at a time 2.0 sec. after the Main Motor (M1) has started turning is less than 5% (greater than 4.63 V). - The measurement taken by the ATDC
ATDC Sensor - The measurement taken by the ATDC Sensor (UN1) at a time 2.0 sec. after the Main Motor (M1) has started turning is less than 5% (greater than 4.63 V). - The measurement taken by the ATDC
...ATDC sensor malfunction.Check the ATDC sensor(auto toner density control) and the connection between the imaging unit and copier,replace the PWB-A board or replace the ATDC sensor.If the copier ...
ATDC Sensor Failure ? The scanning value of the ATDC Sensor is less than 7 % while the IU Motor is turning. ? The scanning value of the ATDC Sensor is more than 19 % while the IU Motor is turning. The
ATDC sensor has detected some low readings. The ATDC sensor measures the toner level inside the developer unit. Try swithcing on/off, open/close the front door to clear the error code. If this doesn't
Question about Konica Minolta Office Equipment & Supplies
ATDC Sensor - The measurement taken by the ATDC Sensor (UN1) at a time 2.0 sec. after the Main Motor (M1) has started turning is less than 5% (greater than 4.63 V). - The measurement taken by the ATDC
ATDC Sensor Gently swing the IU in the horizontal direction to even out developer in the Developer Mixing Chamber. Clean ATDC Sensor (UN1). Change ATDC Sensor (UN1) and developer. Change Master Board
71 questions posted
Usually answered in minutes!
106 Questions
93 Questions
72 Questions
71 Questions
72 Questions