Pioneer PRS-D5000SPL Car Audio Amplifier "impedance 4ohms" Questions

i have a lanzar vibe 286 its a very good anp and kick hard but it gets very very hot so hot you can **** an eeg on it what shud i doi know i can install a fan on it but were the back or front i dont ...

...impedance to match the amp: 250 watts RMS at 4ohms or 450 watts RMS at 2ohms. If you want to use the amp in bridged mono mode to drive a subwoofer, again Crutchfield has a large selection of subs and ...

impedance. Lower ohms means higher load on the amp. Using a speaker with 4ohms is safe for car amplifiers, some can do 2ohms but very few can safely do less than that. You didn't specify the model but

...impedance that the amp sees up to at least 4ohms or it will continue to shut down and eventually fail completely. If your subs are dual voice coil and can be rewired so that each sub has an impedance ...

...connect the recommended impedance speakers. Eg: If the specs says 1000watts @ 2Ohms on connecting a 4Ohms speaker the Amplifier will only deliver 500watts.But will run cooler and is of course

...4ohms or 2 ohms Hello bully_bread, Your amp will be powering the sub at 4 ohms. The impedance or "load" that the amp sees is determined by the number of voice coil(s), the number of sub(s), and how ...

...4ohms and 500 watts @ 2 ohms. I want to hook up 3 sony 12'' explods @ 4 ohms a piece. How do I wire them to the amp to get the maximum output of 500 watts? THANKS well to be honest your amp probly ...

...impedance on each channel will be 4ohms. You might also want to check the ground connection and make wure that you are getting a good ground. Also, check the sub wiring to make sure that the ...

...impedance of your DVC sub is 4ohms or greater. So a sub with either 2ohm or 4ohm voice coils needs to have the coils wired in series with a jumper between the positive of one coil to the negative of ...

...impedance of the speakers vs the impedance of the amp.The amp needs to be lower or equal impedance than the speekers(IE Speakers are 8ohms each so the amp needs to have an impedance of 4ohms or