Pin Number Wire Color Function 1 White Left Front Positive 2 Green Left Rear Positive 3 Violet Right Rear Positive 4 Grey Right Front Positive 5 Blue/White Amplifier Remote 6 Blue Antenna Remote 7 Red
12 PIN HARNESS NEED TO FIND WHERE TO BUY THE 1210 HARNESS, CLD AUDIOVOX AND TOO HARD TO ORDER. SO, NEED TO KNOW WHERE ELSE I CAN BUY ONE. The 12 pin connector is nearly the same as used on most desk ...
...same problem after hours of testing found that for some reason there was no voltage at the screen made a jumper wire to go from 12 volt input to correct pin on ez view cable and both screens came ...
...pin for at least ten seconds , when you release it it should have reset your unit. If you don't see the reset button , just disconnect the power wire (red) and 12 volt constant power (yellow) for ...
...connection. However, if you are sure of the connections, let us proceed. Check the constant 12 volt for power. Check the accessory power connection for 12 volts when the key is on. Check the ...
...Left (FL) plus (+) speakers 3.Grey (GR) Accessory power [switched on with the ignition switch] +12v 4.Light Blue with Yellow Stripe (L-Y) always +12v [radio memory] 5.Light Blue (L) Front Right ...
...and the like for 50-200 bux or so. hope this helps, trin Via P-BUS you must conect 1 of pins to 12 V and unit is start ...
...12-pin harness wires, not exactly the same color codes as the original harness printed on the housing cover. That's not really the problem and thats the Only set of wires dangling at the back of the ...
15 questions posted
Usually answered in minutes!
240 Questions
257 Questions
245 Questions
227 Questions
184 Questions