Question about Pioneer Audio Players & Recorders
...amplifier vsx-d512 overload message it gives a message overload This indicates the audio output stage in the receiver is loading down and triggering the overload protection circuit to kick in. Check ...
Question about Pioneer Audio Players & Recorders
overload" and receiver shuts down. This means that one (or maybe more) of the amplifiers is shorted. Remove all speakers cables and try again. If you get the same message that means that one (or more)
Question about Pioneer Audio Players & Recorders
Overload = one of the speakers has a lower impedance than the amplifier can sustain, most likely it's shorted. Take them out one at a time till the message is gone and fix it if possible or replace it
Overload usually only appears if you have been using higher volumes for a period of time and this trips to protect your speakers and amplifier. Turning off your amplifier and leaving for a while
Question about Panasonic Audio Players & Recorders
...overload even with all speakers disconnected, then your main amplifier output has a short usually a shorted output transistor is the cause. Unplug the speakers one at a time to and turn the unit on ...
Question about Pioneer Audio Players & Recorders
a compatible Ohm rating for the unit. If you have any equalizer, tone controls or "bass boost" effects enabled, turn those off. They all require more amplifier power, thus possible overload can result
...message on the display? Could be a power supply proection circuit or possibly an output overload protection circuit. Have you disconnected the speakers and all other source inputs and outputs to ...
...out says "OVERLOAD TURN OFF AMPLIFIER AND RESTART"- My speakers are rated at 125 amps in back 350 for front. Thanks. you have too many speakers hooked up to it sucking the juice out of
...is not output the correct voltage or is shorted that will trigger a fault. You could also have an overload condition on the output stage. Too much current drawn by the amplifier will trigger a
...amplifier VSX-d512-s is coming up with the error message OVERLOAD and then immediately switching off. Has worked consistently for four years, this is the first problem Sounds to me like a thermal ...
47 questions posted
Usually answered in minutes!
169 Questions
146 Questions
83 Questions
90 Questions
66 Questions