Technics SA-AX910 Receiver "amp keeps cutting" Questions

keeps cutting out. I have made sure that the amp is ventilated and the speaker wires are securely plugged in. Not sure what else it could be. When it cuts out i have to turn it off and turn it back on

...keeps cutting off. its very annoying... any ways to fix this probem? Check the impedance of the speaker wires going into the amplifier. It sounds like at least one set of speakers is overloading the ...

...amp why does it keep cutting off Try it with only two speakers. Does it have 6 channels? if not you may have damaged one of the output amps. When you connect more than one speaker per terminal (in ...

...amp plays for a while before cutting off, it's probably a thermal problem in the output stages. One of the output devices may be acting up as it heats up, or it could be bad connections that open up ...

power keeps cutting off. stays on for 3 seconds Could be either a problem with the amp or a bad voltage regulator. Hard to tell without checking some things inside.

...keeps saying overload when i have the volume further than 40db. Never use to do it... and i have re wired the speakers and the amp, cut them, ensured no frays. Also tested the amp at max volume when ...

stereo turns off when volume is turned up the receiver has a built in cut off. if you over work the amp inside it will shut off. try keeping the volume down a little bit

...keeps clicking over to standby. This now happens at least every 5 or 10 minutes. I keep powering up again but it continues to click over to STANDBY. Please help. Not an expert on this amp But going ...

...KEEPS SHUTTING DOWN IF THE VOLUME GOES TO HIGH. I WAS TOLD IT WAS DOING THAT TO KEEP FROM BLOWNING MY SPEAKER AND THEY WERE TO SMALL. SO, I A PAIR WHICH IS DESIGN FOR 400WATTS PER CHANNEL ( I THINK ...

...unit out & swop the RED & YELLOW wires over, either by cutting them and re joining them red to yellow & yellow to red, or by pulling them out of the ISO block & switching them