flashing red status light This project has a flashing red status light and no lamp The projector will turn on and the start up process is normal until the light should turn on. Then status light which
Status light is flashing Hello, I have a lt35 projector, the status light is flashing and according to the manual this indicates a temp problem. I have left the unit in stanby and then switched off at
...status light flashing red on WT610 NEC if the status light is flashing .5 seconds on and 2.5 seconds off - you need to replace the lamp cover correctly. if the status light is flashing .5 seconds on ...
Question about NEC Office Equipment & Supplies
status as green then it goes to a flashing orange light there should be a status for the lamp light; check to see if this one turns red. If it does count the consecutive blinks if it is 6 then replace
Question about Mitsubishi Office Equipment & Supplies
...status light flashing green then switching off So our projector has stopped working. The bulb was replaced a few months back so it's not that and the projector is normally ceiling mounted so ...
Question about NEC Office Equipment & Supplies
...replaced only two months ago? when i turn the power off and on the status light goes green for about 30 secs then beeps about 3 times then turns to a flashing red. Help you need to reset the lamp ...
...Status is flashing red - then there are 4 flash combinations. 1 cycle (0.5sec On, 2.5sec Off) lamp cover or housing error 2 cycle (0.5sec On, 0.5sec Off) temperature error 4 cycle (0.5sec On, 0.5sec ...
status keeps flashing green for about 20 seconds. Power light then comes on green again and status turns amber, unit shuts off. Tried the "<> power" reset, no change. Last time
Question about Mitsubishi Office Equipment & Supplies
...status light flashes green. Do I need a new lamp or what? Thanks. your projector status means the protection circuit is working or the lamp is in an abnormal condition. --wait until status indicator ...
Question about Epson Office Equipment & Supplies
...the power button. 3. After status light 1, 2, and 3 flash ON and OFF at least three times, release the Comp Sync + and the power button. The flashing lamps status indicate that the lamptimer is
20 questions posted
Usually answered in minutes!
75 Questions
41 Questions
39 Questions
27 Questions
39 Questions