...status light This project has a flashing red status light and no lamp The projector will turn on and the start up process is normal until the light should turn on. Then status light which started out ...
Question about NEC Office Equipment & Supplies
Status light blinks red bulb replaced only 2 months ago Status light blinks red bulb replaced only two months ago? when i turn the power off and on the status light goes green for about 30 secs then ...
Question about NEC Office Equipment & Supplies
...green then it goes to a flashing orange light there should be a status for the lamp light; check to see if this one turns red. If it does count the consecutive blinks if it is 6 then replace the ...
...status and power light started flashing red and orange and there is no picture if Power is flashing orange - then it's cooling down if Status is flashing red - then there are 4 flash combinations. 1 ...
Question about Mitsubishi Office Equipment & Supplies
...status light flashing green then switching off So our projector has stopped working. The bulb was replaced a few months back so it's not that and the projector is normally ceiling mounted so ...
Question about NEC Office Equipment & Supplies
...status light on NEC VT45 projector There is a flashing red light on our school's VT45 projector. The lamp has been replaced but the flashing red light remains. Any suggestions to try? make sure the ...
...status light flashing red on WT610 NEC if the status light is flashing .5 seconds on and 2.5 seconds off - you need to replace the lamp cover correctly. if the status light is flashing .5 seconds on ...
...technical support, if the status light flashes red six times, this could indicate a defective lamp. If a new lamp is installed and the project still won't turn on, the projector will need
Question about NEC Office Equipment & Supplies
...status light flashing a series of 6 flashes red. Inside I found that the filter on the lamp enclosure was blocked. last time i tried to fire it up i did it with the top cover off, holding the lid ...
Question about Mitsubishi Office Equipment & Supplies
...status light flashes green. Do I need a new lamp or what? Thanks. your projector status means the protection circuit is working or the lamp is in an abnormal condition. --wait until status indicator ...
35 questions posted
Usually answered in minutes!
75 Questions
41 Questions
39 Questions
27 Questions
39 Questions