NEC MultiSync MT1050 Multimedia Projector "fan working" Questions

you're sure the fan works but no voltage, hope you're good at soldering. you need to remove the main board and solder a jumper from the bad fan's power and ground to the working fan's power and ground

fan working fan not working you must test the voltage terminal Fan, if there are the FAN is faulty, if there are NOT the problem is fuse, or loose or faulty connection to the FAN. Merry Christmas

Fan not working Just replaced the bulb and now our fan stopped working so the projector turns on and then after a minute it turns off. The fan never turns on. This suggests the bulb is not correctly ...

...fan not working or a bad power supply/ballast. If it is a fan that is not working it will cause it to shut down. That would either be a bad fan or bad main board. But, if all fans are working, most ...

...one into the working fan's socket to make sure the fans work. if they don't replace them. if they do, you have a main board issue. the fans have a 3rd wire that senses rpms, so they can't be

working. I can't find a replacement fan. Could you tell me the company you used to fix your unit? hope this help someone,take out the bulb for 5 minutes,while out spray dust off inside,then place bulb

FAN ERROR BUT THE FANS WORK I have a TLP-S10 that got a fan error after I blew air through it to remove dust. I opened it all up and determined that all the fans actually work so i'm stumped. If you ...

...fan not working The fan is a brushless fan and very reliable but they do go wrong check to see if you have the supply to the fan assembly there are usually three wires two are the supply the other is ...

...Locked - Projector will be shutdown - Call service for repair. But Fan is working good !! Does any one know why ? there must be a fan sensor defective or dirty. must change fan to same fan model

...When the projector is running for 20 minutes the image on the projected screen freezes. The fans remain running and the projector can only be shut down by eliminating the power supply. The ...