pro leaf blower is also a leaf mulcher, and after using it from last year I tried starting it and the cord would not go back in. I sprayed some wd40 on the pulley and now the cord retracts. It started
...pro leaf blower Here is my Tip that will solve the problem: www.fixya.com/support/r6081405-cleaning_small_engie_carburetor One other thing you can check if the carburetor cleaning doesn't do the ...
Question about Poulan Garden
...Pro leaf blower does not get fuel to the carburator. It isn't very old. The filter was off and on the bottom of the fuel tank. I replaced the fuel ines. I have switched the lines and tried I ...
...Pro leaf Blower and can not get it to start. Installed new plug, checked spark and it is ok, sprayed starter fulid and it would not even fire. Plug wet with gas each time, and yet if I ground the new ...
Pro bvm200fe? I still can't get it to start. I've tried a new spark plug, bought a new ignition coil, and fully broke it down and cleaned it and still get it to even attempt to start. If you do indeed
Question about Poulan Garden
...Poulan Pro Leaf Blower/vacuum to start, but it won't idle and won't run smoothly, it "surges". I've cleaned carburator plug and filter. check the motor and clean all dust....tight the all loosen ...
my poulan pro bvm200vs will not start. took the soark plug out and it was wet and smelled of gas. cleaned the plug,replaced it and ran for three seconds. Problem is likely a stuck needle valve or ...
Question about Poulan Garden
...Pro BVM200FE blower won't start. It will turn over a few times after 3-4 pulls then nothing. Since it will run a few cycles I would think it's not an electrical problem, maybe not getting gas ...
Question about Poulan PRO® Garden
how do i know i am getting a spark when i pull the starting cord? I have cleaned the carb. I am getting gas. I have a new spark plug. But it will not crank when I pull the cord. it will jump the plug ...
pro bvm200 leaf blower/vac won't run on high won't run at high speed. gas and oil mixture is ok, spark plug ok, the carb adjustment screw will not adjust to where the blower will run at high speed. It
99 questions posted
Usually answered in minutes!
583 Questions
457 Questions
255 Questions