...39;ve loaded the PTO hard enough to burn the clutches out (which I doubt very much) it can only be that fluid is not getting to the clutches. Chances that there is a problem inside the tractor with ...
...39;s driveshaft which engages the bottom pulley, running the deck. you might luck out and find the fuse is blown so follow the wire from the PTO back until you find the fat part in the wire. the fat ...
Question about Garden
...PTO won39;t engage. Water is filled in battery cells and the mower can go forward and reverse, but the blades won39;t turn. I After starting my John Deere LX277 the battery light goes on and the ...
...pto won39;t engage when pulling switch, can39;t find out why can get it to run jumping straight to battery if I put a toggle on this set up is it going to burn anything up any advice appreciated ...
pto light stays on, tractor won39;t start (4400) Had been spraying in the pasture. When I came in, with the pro off, I noticed that the pto light stayed on. I switched the pto on and off and the ...
39;s a two cylinder engine. Remove the belt from the deck and make sure the spindles spin freely, if so then run the engine without belt installed and engage PTO to see if PTO is binding - could
...PTO it will not engage. the safety system wouldn39;t know if the clutch its self had failed see if your getting power to the clutch with some one on the seat or a jumper on that switch the clutch ...
Question about John Deere Garden
...39;t engage when i push the pto switch on dash Sounds like you have a loose or broken wire. It may have an inline fuse that blew. I would start at the switch and work my way down checking the wires ...
...wire 39;T39; plug from the PTO clutch and disconnect. With a voltmeter across the the 2 spades on the tractor side of the plug you should get 12 volts DC with the PTO switch on ( you may need to ...
165 questions posted
Usually answered in minutes!
1,057 Questions
111 Questions
134 Questions
149 Questions
88 Questions